Fork truck canopy

Advertisement

November 11th,2019

SPECIFICATION CUM COMPLIANCE CERTIFICATE OF FORK LIFT …

SUPPLY & COMMISSIONING OF 2 T DIESEL OPERATED FORK LIFT TRUCK. COMPLYING AS PER SPECIFICATION BELOW NOTE : 1. VENDOR must submit complete information against clause No. 6.0 ( Qualifying condition). The offer meeting this clause would only be processed. SPECIFICATION CUM COMPLIANCE CERTIFICATE OF FORK LIFT TRUCK 2. The offer and all documents ...

November 11th,2019

TENDER DOCUMENT FOR PURCHASE OF: SUPPLY OF DIESEL …

technical specification of diesel forklift truck of 02 ton capacity diesel operated fork lift truck of 02 ton at 500 mm load centre with 1000 mm long forks, single drive , three stage clear view full free lift mast , pnuematic tyres, four stroke diesel engine, automatic hydrodynamic transmission and heavy duty air filter

November 11th,2019

INSTRUCTIONS TO TENDERERS FOR FILLING TECHNICAL BID

Mech/M&P/3200/06 Rev-Nil Fork Lift Truck Cap-3 Ton 4 of 8 01.06.2017 fuel and hydraulic tanks fitted with magnetic drain plug and having large inspection & maintenance windows. Operator Overhead Guard should be provided to protect the operator from overhead objects. The suitable elegantly designed canopy, integrated with

November 11th,2019

FACT SHEET 12 THE LEGAL REQUIREMENTS FOR FORK LIFT …

Fork Lift Truck Association Fact Sheet 14 Issued June 2007 FACT SHEET 12 THE LEGAL REQUIREMENTS FOR FORK LIFT TRUCK OPERATOR REFRESHER TRAINING There is no legal requirement for fork lift truck operators to receive routine refresher training. Such training may be needed in certain circumstances. The HSC Approved Code of Practice and Guidance (L117) states the following: “There is no specific …

November 11th,2019

INSTRUCTIONS TO TENDERERS FOR FILLING TECHNICAL BID

Mech/M&P/3100/GM/25 Rev-Nil Fork Lift Truck Cap-5 Ton 4 of 8 23.05.2017 fuel and hydraulic tanks fitted with magnetic drain plug and having large inspection & maintenance windows. Operator Overhead Guard should be provided to protect the operator from overhead objects. The suitable elegantly designed canopy, integrated with

November 11th,2019

OPERATING RULES FOR INDUSTRIAL TRUCKS

Forks on fork-equipped industrial trucks may be in the raised position for loading and unloading by the operator if the forks are raised no more than 42 inches above the level on which same the industrial truck is located, the power is shut off, controls placed in neutral and the brakes set. If on

November 11th,2019

www.bhel.com

The forklift truck is to be supplied complete with tool kit, canopy and all other accessories needed for successful operation/commissioning. SPECIFICATION: l. Capacity (Lifting Load) l. 2. Load center Overall height with *mast full lowered 3. Max. fork height 4. Over all length with fork face 5. 6. Turning radius Fork length 8. Overall width

Advertisement